Document's / MISC

A REPLACEMENT OF HDD DRIVE IS REQUIRED BEFORE YOU BEGIN: ☐ Print out this article ☐ Fill in the relevant information below ☐ Prepare with screwdriver Phillips for M3 ☐ Which HDD should be replaced, A or B, you should have received this information from the Telko Service Department VESSEL INFORMATION: VESSEL: IMO: HDD SERIEL NUMBER: The serial number starts with ISN NEW HDD: ISN OLD HDD: ISN PHYSICAL REPLACEMENT OF HDD: ☐ Push the power button once and wait for it to power off ☐ Di...

Please see the attached document for integration with Data over networks such as Modbus, UPC-UA, etc.

If you have Automation Sensors connected to TELSCOPE, you can toggle between Manual or Automatic, see picture below. New Installation: After the Telko Support Department has done a configuration of the system, the crew needs to switch all Machinery to (Is Automatic). To do this, go to: - Engine - Machines - Settings - Set "Is automatic" to on

The installation checklist is mandatory and must be handed over to the captain after installation

TELSCOPE data collection can be broadly divided into two categories: Navigation data, and engine room data Navigation data TELSCOPE requires an IEC 61162-1 (NMEA) serial connection to a GPS providing compliant sentences for position, time and speed/course over ground: - Position: GGA, GLL, GNS, RMC - Course over ground (COG): RMC, VTG, OSD - Speed over ground (SOG): RMC, VTG, OSD TELSCOPE will also make use of additional provided navigation data provided via IEC 61162-1 (NMEA) compliant sent...